Crane Merchandising Systems 670, 678 Hot Drink Setup/Programming Guide, Standard Coin Mechanism

HOT DRINK SETUP/PROGRAMMING GUIDE

6. Set Up and Load the Coin Mechanism

Standard Coin Mechanism

Setting the Quarter Switch. If your coin mechanism is not a MARS TRC 6000, skip this procedure and begin LOADING THE COIN MECHANISM.

a.Flip down the front of the coin

mechanism as shown, and set the quarter switch.

Load the Coin Mechanism.

a.Open the cabinet door and the monetary door.

b.Insert coins into their respective tubes until each tube has been filled.

c.Inspect the tubes for shingled coins and correct if necessary.

MDB Coin Mechanism

Install the coin mechanism as follows:

WARNING

Make sure the main power switch is turned OFF before you work on the merchandiser. Failure to do so could result in death or injury.

a.Turn OFF the main power switch. Refer to the instructions provided with the coin mechanism and remove the coin validator assembly.

b.Loosen the coin mechanism mounting screws on the merchandiser so they stand off about 1/8" (0.3 cm).

c.Position the coin mechanism so the three keyed holes fit over the mounting screws. Pull down on the coin mechanism to seat the screws in the keyways.

d.Tighten the mounting screws and reinstall the coin validator assembly.

November, 2002 Page - 12 6700001