Crane Merchandising Systems 678, 670 manual Assign Cup Sizes To Selections Supervisor Mode Only

HOT DRINK SETUP/PROGRAMMING GUIDE

ASSIGN CUP SIZES TO SELECTIONS (SUPERVISOR MODE ONLY)

You can load up to two different sizes of cups in your machine (see set up cup sizes, page ). You may not always want a certain selection to use all of the cup sizes in your machine. For example, espresso is normally served in regular cups, so you probably will not want it to be available in large or jumbo cups.

1. Press , then press , until the display shows something

like this: O. ABCDEFGH. This display means that the smaller of the two cup sizes (0) is available for selections (A-H).

2.Press selections.

3.Press

to display all selections; press to clear all

to display remaining selections (0 YZ2_ _ _ _ ). In

this display, the “Y and Z” represents the blended product, and the “2” represents the cup only selection.

NOTE:

If you have only one cup size in your machine, you will not see the next display.

4. Press . The display shows something like this:

1.ABCDEFGH. This display means that the larger of the two cup sizes (1) is available for all selections (A - H).

5.Press the appropriate letter to toggle the display on or off. A se- lection that doesn’t vend the displayed size cup has its letter re- placed by a dash (-).

6. Press to display all selections; press to clear all

selections.

7. Press

to display remaining selections (1 YZ2_ _ _ _ ).

In this display, the “Y and Z” represents the blended product, and the “2” represents the cup only selection. (Continued)

6700001 Page - 41 November, 2002