Crane Merchandising Systems 678, 670 manual Test Various Sensors And Switches, Payout Coins

HOT DRINK SETUP/PROGRAMMING GUIDE

TEST VARIOUS SENSORS AND SWITCHES

1. Press , then press until the display shows

IN.XXXXXX. The X's in the display will be replaced by the following

place holders:

MK P H L 1, defined as follows:

M = mug/cup sensor (if equipped)K = freevend keyswitch

P = waste pail switch	H = high water tank level
switch
L = low water tank level switch	1/2 = ring 1/2 cup sensor
switch

2.Actuate each switch or sensor to test its function. As you actuate each input, the display element representing that switch blinks on. Releasing the switch causes that element to blink off again, and be replaced by a dash.

3.CONTINUE.

PAYOUT COINS

1. Press . If a dumb mech was selected, the display shows

NDQ =123; if an MDB mech was selected the display shows PAY

2. Press	. A dumb mech pays out one Nickel; an MDB mech
pays a coin from tube 1. Press		. A dumb mech pays out one
Dime; an MDB mech pays a coin from tube 2. Press			. A

dumb mech pays out one quarter; an MDB mech pays a coin from tube 3.

3.To continuously pay out coins, hold down the appropriate key.

4.CONTINUE.

6700001 Page - 91 November, 2002