Crane Merchandising Systems 670, 678 manual Options, View Or Set The Hot Water Tank Temperature

HOT DRINK SETUP/PROGRAMMING GUIDE

OPTIONS:

a. At any of the preceding displays, you can press to test

throw that item.

b.At any of the preceding displays, you can press * or # (on the se- lection switch panel) to step through a list of that item’s throw times for other selections where that item is active. For example, pressing

# at the WAT. A display will show the throw time for WAT. B. This is a handy way to move from one selection to another without going to the SETUP screen first.

NOTE

If you try to set up a selection that is not configured, the SETUP screen will remain in the display.

5. Continue.

VIEW OR SET THE HOT WATER TANK TEMPERATURE

1. Press then until the display shows SET 202 °F .

In this example, 202° is the water tank temperature setpoint in de- grees Fahrenheit. If a decimal point appears next to the “F”, the heater is on.

2.If desired, enter a new setpoint in the accepted range of 149° - 205° F (65° - 96° C).

NOTE

The lower limit for vending is 20° below setpoint, up to a maximum of 180° F (82° C).

3.To change display units (replace the “F” with a “C” for Celsius), press

.

4.Continue.

November, 2002 Page - 44 6700001