Crane Merchandising Systems 678, 670 manual Hot Drink Setup/Programming Guide, Mount the Base Plate

HOT DRINK SETUP/PROGRAMMING GUIDE

2. Mount the Base Plate:

WARNING

DO NOT MOVE THE CABINET WHILE HEX

HEAD SCREWS AND/OR CARRIAGE

BOLTS ARE LOOSENED. THE CABINET

WOULD BECOME UNSTABLE AND LIKE-

LY TO TIP AND CAUSE INJURY.

a.Remove the pail(s) from the inside of the merchandiser.

b.Remove the floor liner from the inside of the merchandiser.

c.Remove the two caps as shown.

d.Loosen the left leg assembly carriage bolts and nuts to allow mounting a base plate bracket.

e.Secure one of the base plate brackets to the leg assembly using the two carriage bolt. Tighten the carriage bolts and nuts.

f.Loosen the right leg assembly hex head screws to allow mounting the other base plate bracket.

g.Secure the other base plate bracket to the right leg assembly using the two hex head screws. Tighten the hex head screws.

h.Insert the short arms of the slides into the hinged tabs of the base plate. Position the slide so the notch near the short arm is on the bottom side.

i.Insert the long arms of the slides into the base plate brackets.

j.Insert and secure a cotter pin through the hole in the back of each of the slides.

k.Push the base plate toward the merchandiser cabinet. The front tabs of the base plate brackets should seat in the notches in the long arms of the slides.

l.Replace the caps, liner, and pail(s) removed previously.

CAPS

SLIDE - L.H.

BASE PLATE BRACKET

COTTER PIN

BASE PLATE

ASSEMBLY

SLIDE - R.H.

6700001 Page - 5 November, 2002