the SET button, turn the power on. Then change the setting after the signal transmission has stopped.

transmitter first. Then, while holding down the SET button, turn the power on. And then, change the setting after the signal transmission has stopped.

Setting the RF Output

Power (RF POWER)

You can set the RF output power.

1 mW (LOW): transmitted by 1 mW

10 mW (MID): transmitted by 10 mW

50 mW (HIGH): transmitted by 50 mW

Using wireless remote control, this function can be controlled from the receiver and other devices.

Note

The setting for this function cannot be changed during actual signal transmission. To change the setting, turn off the

Setting the audio input

level (INPUT LEVEL)

You can set the input level to an analog head amp.

Select LINE or MIC, depending on the audio source connected to the audio input connecter.

When MIC is selected, the ATT (attenuation) level will flash next. With the microphone connected, speak into the microphone as you monitor the input level meter and press the + or – button repeatedly to select the appropriate attenuation level. The reference levels for the various settings are as follows:

Input

Attenuation

Reference input

Maximum input

Headroom (dB)

 

(dB)

level (dB)

level (dBu)

 

MIC

0

–58

–22

36

 

 

 

 

 

 

3

–55

–19

 

 

 

 

 

 

 

6

–52

–16

 

 

 

 

 

 

 

9

–49

–13

 

 

 

 

 

 

 

3 dB step

3 dB step

3 dB step

 

 

 

 

 

 

 

45

–13

+23

 

 

 

 

 

 

 

48

–10

+24

34

 

 

 

 

 

LINE

–

+4

+24

20

 

 

 

 

 

With the wireless remote control function, the attenuation level can be changed from the receiver and other devices.

 

20

30

40

50

60

70

80

90

100

Low-cut filter setting (LCF)

120

140 160

180

200

220 (Hz):

The frequency of the low-cut filter can be

Low-cut filter is set according to the

selected frequency.

set.

 

OFF: Turns off the low-cut filter.

 

Setting menus 33