3-6. BASE UNIT (BU-5BD27)
Note: When installing the BU on the chassis, set the lever (lifter) in free position, the gear (U/D) in UP position, and insert the shaft b into the groove of gear (U/D).
4two screws (PTPWH M2.6)
BU section
b
gear (U/D)
lever (lifter)
34 two screws (PTPWH M2.6)
5 base unit
6 four compression springs (932)
1 wire (flat type) (21 core) (CN101)
| 2 two screws |
7 holder (BU) assy | (PTPWH M2.6) |
|
3-7. TABLE ASSY
9 three screws (BTTP M2.6)
e
qs table assy
q; clamp
qa bracket (guide)
gear (loading C)
3
2 two screws (BTTP M2.6)
7two screws (BTTP M2.6)
8 bracket (guide 2)
4wire (flat type) (6 core) (CN15)
5 screw (BTTP M2.6)
6bracket (guide)
Note: When installing the table assy on the chassis assy, engage
the gear (loading C) with the groove by looking into the gear through
a hole e in the table assy.
| 1 Slide the tray until the screw |
| that fixes the bracket (guide) |
| can be seen through a round |
d | hole c , d in the table assy. |
c
11