Sony service manual CDP-CE575 SECTION TEST MODE, Adj Mode, ADJ Mode Special Function Table

CDP-CE575

SECTION 5

TEST MODE

ADJ MODE

NOTE: This mode cannot be performed without a general remote com- mander.

1.Chuck the CD first, and then turn OFF the power.

2.Short-circuit the test point TP (ADJ) of the MAIN board and ground with a lead wire.

3.Press the [POWER] button to turn ON the power.

The CD is playback the 2nd track automatically and the ADJ mode is set.

4.To exit the mode, press the [POWER] button to turn OFF the power.

ADJ Mode Special Function Table

Button	Function
DISC 1	RFDC display
DISC 2	Decision of Disc size (8/12 cm)
DISC 3	Change the slice level
DISC 4	Change the focus bias (high/middle/low)
DISC 5	Track jump (1st y 20th)
TIME/TEXT	TRK off/on
M	Offset (VC), EF bias display
m	Offset (RF, FE, TRK) display
EX-CHANGE	Focus bias down
DISK SKIP	Focus bias up
X-FADE	Track gain up/down
EDIT	Disc kind (aluminum/RW), side (8/12 cm) display
CHECK	S-curve mode
CLEAR	RFCK t GFS t error rate display
PEAK SERCH	Best point of focus bias, jitter value display
FADER	Auto gain display

FLUORESCENT INDICATOR TUBE, LED ALL LIT, AND KEY CHECK MODE

1.Short-circuit the test TP (AFADJ) of the MAIN board and ground with a lead wire.

2.Press the [POWER] button to turn ON the power. The whole fluorescent indicator tube lights up.

3.All buttons have individual button numbers.

When a button is pressed, the button number is counted up and displayed.

Connecting Location:

– MAIN BOARD (Component Side) –

TP (AFADJ)

R301

TP (ADJ)

10

button number Displays button number

When remote controller signals are received, “RM **” will be displayed.

(** are the numbers corresponding to the remote controller buttons)

When using the remote controller, switch the [CD1/2/3] switch to CD1.

4.To exit the mode, press the [POWER] button to turn OFF the power.

14