Changing the sound and display settings

The following items can be set: •Clock (page 7).

•CT (Clock Time) (page 20).

•D.Info (Dual Information)*1 – to display the clock and the play mode simultareously (ON) or to display the information alternately (OFF).

•Amber/Green – to change the illumination colour to amber or green.

•Dimmer – to change the brightness of the display.

—Select “Auto” to dim the display only when you turn the interior lights on.

—Select “on” to dim the display.

—Select “off” to deactivate Dimmer. •Contrast – to adjust the contrast if the

indications in the display are not recognisable because of the unit’s installed position.

•Beep – to turn the beep sounds on or off. •RM (Rotary Commander) – to change the operative direction of the controls of the

rotary commander.

—Select “norm” to use the rotary commander in the factory-set position.

—Select “rev” when you mount the rotary commander on the righthand side of the steering column.

•L.out (Line output)*2 (page 24)

•Loud (Loudness)*1 – to enjoy bass and treble even at low volumes. The bass and treble will be reinforced.

•LPF (Low Pass Filter)*1 (page 23)

•M.dspl (Motion Display) – to turn the motion display to 1, 2, or off.

•A.Scrl (Auto Scroll)*1 (pages 9, 25)

1 Press (SHIFT).2 Press (3) (SET UP) repeatedly until the desired item appears.

Each time you press (3) (SET UP), the item changes as follows:

Clock nCT nD.Info*1 nAmber/Green n Dimmer nContrast nBeep nRM nL.out*2

nLoud*1 nLPF*1 nM.dspl nA.Scrl*1

*1 When the radio is off, or when no CD, or MD is playing this item will not appear.

*2 When the optional equalizer preamplifier is not connected, this item will not appear.

Note

The displayed item will differ depending on the source.

3 Press (5) (n) to select the desired setting (Example: on or off).

For the “Contrast” setting, pressing

(5)(n) makes the contrast higher, and pressing (2) (N) makes the contrast lower.

4 Press (SHIFT).

After the mode setting is complete, the display returns to normal playback mode.

Adjusting the frequency of the subwoofer(s)

To match the characteristics of the connected subwoofer(s), you can cut out the unwanted high and middle frequency signals entering the subwoofer(s). By setting the cut-off frequency, the subwoofer(s) will output only low frequency signals for a clearer sound image.

1 Press (SOURCE) to select a source (radio,CD or MD).2 Press (SHIFT), then press (3) (SET UP) repeatedly until “LPF” appears.3 Press (5) (n) or (2) (N) repeatedly to select desired setting.

SET UP

Each time you press (5) (n) or (2) (N), the cut-off frequency in the display changes as follows:

LPF off ÷LPF 80 Hz ÷LPF 120 Hz

4 Press (SHIFT).

When the frequency setting is complete, the display returns to the normal playback mode.

23