5 Select the desired station by pressing the preset number button or pushing the SEEK/AMS control up or down.

6 Press (TIR) for two seconds to return to the original display.

tlights up.

8

The unit turns on automatically and stands by for traffic announcements for four hours (two hours before and after the preset time).

If the preset station does not broadcast the traffic announcement while searching, the unit starts searching for other traffic programme (TP) stations.

To cancel the TIR functionSelect “TIR off” in step 2 above.

Tips

•While the unit is recording the traffic announcement, tand “TA” flash.

•If the unit still cannot find a TP station, it starts a new search every five minutes until it finds one.

•If you pull out the ignition key while the TIR function is on, “TIR on” and tflash a few times.

Notes

•The unit also stands by for traffic announcements for two hours after you turn off the engine, as long as the TIR function is on.

•If you have a power aerial, it automatically extends every time the unit searches for a traffic programme station.

If you have a manual aerial, make sure that the aerial is fully extended.

•If you do not use your car for about ten days, the TIR function will turn off automatically to avoid battery wear, even if the TIR function is on.

•While the unit is recording or playing back the traffic announcements, the voice drive function and voice memo function do not work.

Playing back the recorded traffic announcements

When there are recorded traffic announcements you have not listened to yet,

tflashes.

1 Press (TIR).

The latest traffic announcement is played back. To listen to the previous ones, press (TIR) or push the SEEK/AMS control up. To replay the announcements, push the SEEK/AMS control down.

“NO Data” appears if no traffic announcements were recorded.

2 Press (TIR) to go back to the original programme.

EN

RDS

19