Sony CDX-C880R Listening to each programme source in its registered surround menu, Additional, Information, Precautions, Changing the line output level, 3 Press (SHIFT)

4 Rotate the dial to select the turn-over frequency.

The turn-over frequencies change as follows:

Bass:

198 Hz n250 Hz n314 Hz* n396 Hz

Treble:

2.0 kHz n3.1 kHz* n4.0 kHz n5.0 kHz *Factory-set frequency

5 Press (SOUND)fortwoseconds.

The display returns to the normal playback mode.

Listening to each programme source in its registered surround menu

— Last Sound Memory (LSM)

Each time you return to the same source, you can hear the same surround effect registerd for that source, even after changing the programme source or turning the unit off and then on again.

Changing the line output level

You can change the line output level if you hear distortion or other noise.

1 Press (SHIFT),thenpress (3)(SETUP) until “L.out” appears.

2 Press (5) n)toselectthedesired setting(–10dBor–16dB).

3 Press (SHIFT).

AdditionalInformationPrecautions

•If your car was parked in direct sunlight resulting in a considerable rise in temperature inside the car, allow the unit to cool off before operating it.

•If no power is being supplied to the unit, check the connections first. If everything is in order, check the fuse.

•If no sound comes from the speakers of

two-speaker systems, set the fader control to the centre position.

•If your car is equipped with a power aerial, it will extend automatically while the unit is operating.

If you have any questions or problems	EN
concerning your unit that are not covered in	DSP/Additional
this manual, please consult your nearest Sony
dealer.
Notes on handling CDs
A dirty or defective disc may cause sound
dropouts while playing. To enjoy optimum	Information
sound, handle the disc as follows.
Handle the disc by its edge. To keep the disc
clean, do not touch the surface.
Do not stick paper or tape on the labelled
surface.

continue to next page n

39