Other functionsChanging the sound settingsAdjusting the sound characteristics — BAL/FAD/SUB

You can adjust the balance, fader, and subwoofer volume.

1Press (SELECT) repeatedly until “BAL,” “FAD” or “SUB” appears.

The item changes as follows:

LOW*1 t MID*1 t HI*1 t

BAL (left-right) t FAD (front-rear) t SUB (subwoofer volume)*2 t AUX*3

*1 When EQ3 is activated (page 12).

*2 When the audio output is set to “SUB” (page 12).

“ATT” is displayed at the lowest setting, and can be adjusted up to 20 steps.

*3 When AUX source is activated (page 15).

2Rotate the volume control dial to adjust the selected item.

After 3 seconds, the setting is complete and the display returns to normal play/reception mode.

With the card remote commander

In step 2, to adjust the selected item, press <, M, , or m.

Customizing the equalizer curve— EQ3

“CUSTOM” of EQ3 allows you to make your own equalizer settings.

1Select a source, then press (EQ3) repeatedly to select “CUSTOM.”

2Press (SELECT) repeatedly until “LOW,” “MID” or “HI” appears.

3Rotate the volume control dial to adjust the selected item.

The volume level is adjustable in 1 dB steps, from –10 dB to +10 dB.

Repeat steps 2 and 3 to adjust the equalizer curve.

To restore the factory-set equalizer curve, press and hold (SELECT) before the setting is complete.

After 3 seconds, the setting is complete and the display returns to normal play/reception mode.

Tip

Other equalizer types are also adjustable.

With the card remote commander

In step 3, to adjust the selected item, press <, M, , or m.

Adjusting setup items — SET

1Press and hold (SELECT).

The setup display appears.

2Press (SELECT) repeatedly until the desired item appears.

3Rotate the volume control dial to select the setting (example “ON” or “OFF”).

4Press and hold (SELECT).

The setup is complete and the display returns to normal play/reception mode.

Note

Displayed items will differ, depending on the source and setting.

With the card remote commander

In step 3, to select the setting, press < or ,.

The following items can be set (follow the page reference for details):

“z” indicates the default settings.

CLOCK-ADJ(Clock Adjust) (page 5)

CT*1 (Clock Time)

To set “CT-ON” or “CT-OFF” (z) (page 10, 11).

BEEP

To set “BEEP-ON” (z) or “BEEP-OFF.”

AUX-A*2(AUX Audio)

To turn the AUX source display “AUX-A-ON” (z) or “AUX-A-OFF” (page 15).

A.OFF (Auto Off)

To shut off automatically after a desired time when the unit is turned off: “A.OFF-NO” (z), “A.OFF-30S (Seconds),” “A.OFF-30M (Minutes)” or “A.OFF-60M (Minutes).”

REAR/SUB*2

To switch the audio output.

–“REAR-OUT” (z): to output to a power amplifier.

–“SUB-OUT”: to output to a subwoofer.

DEMO*2 (Demonstration)

To set “DEMO-ON” (z) or “DEMO-OFF.”

12