Recording on a tape (continued)
Tips
•(Only when “DUB” is displayed)
When the direction mode of the tape is selected to h:
If the tape is reversed with the recording of the track unfinished, the player will record the track again from its beginning on the reverse side.
When the direction mode of the tape is selected to g:
If the tape reaches to its end, the player stops.
•Adjusting the volume or the audio emphasis (page 32) will not affect the recording level.
•If the AM radio makes a whistling sound after you’ve pressed REC in step 6, press MODE/DIR (MODE on the remote) to select the position of the ISS (Interference Suppress Switch) that decreases noise most.
•To record a specific track of the CD, press MODE/DIR (MODE on the remote) in stop mode to display “1”, then press REC twice (on the remote, while keeping z/X pressed, press Y).
Use these buttons for additional operations
?/1
CD u
STOP x
REC
MODE/DIR
To | Press |
stop recording | STOP x (x in the tape section |
| on the remote) |
|
|
pause recording* | REC once (z/X on the remote) |
| while recording |
| To resume recording, press the |
| button again. |
|
|
turn on/off the player | ?/1 |
*Pause recording is available only when you start recording in pause mode or recording from the radio.
To record a CD from the middle of a track
1Pause playback at the point in the middle of the track where you want to start recording.
2Follow steps 3 - 6 on page 15. Recording starts immediately.
3Press CD u to resume playback.
To erase a recording
1Insert a tape you want to erase into the tape compartment with the side you want to erase facing up.
2On the player: press REC twice.
On the remote: while keeping z/X pressed, press Y.