Troubleshooting (continued)
“No File” is displayed.
•You are trying to play a
Radio
The audio is weak or has poor quality.
• Move the player away from the TV.
The picture of your TV becomes unstable.
•If you are listening to an FM programme near the TV with an indoor aerial, move the player away from the TV.
Tape Player
The tape does not move when you press an operation button.
•Insert the tape properly and close the tape compartment securely.
The REC button does not function/The tape does not play.
•Make sure the safety tab of the tape in the tape compartment is in place. If not, “No Tab” will be displayed.
•Press FUNCTION to switch the function of the player to “TAPE”.
The tape does not erase completely.
•Clean the erasing heads (see page 45).
•The source which was recorded on TYPE II (high position) or TYPE IV (metal) tape is being played. Record on TYPE I (normal) tape and play.
The tape does not record.
•Make sure the tape is inserted properly. If not, “No Tape” will be displayed.
•Make sure the safety tab of the tape in the tape compartment is in place. If not, “No Tab” will be displayed.
The audio is weak/The audio quality is poor.
•Clean the heads, pinch rollers and capstans (See page 45).
•Demagnetize the heads using a demagnetizer (see page 45).
The tape player cannot be paused during playback.
•The tape player can be paused during recording only.
Timer
The timer does not operate.
•Make sure the time on the clock is correct.
•Check to see if the AC power had been cut off.
•Make sure the tape has not wound to the end.
•Make sure the 
(clock) indicator is displayed.
Remote
The remote does not function.
•Replace all the batteries in the remote with new ones if they are weak.
•Make sure that you are pointing the remote at the remote sensor on the player.
•Remove any obstacles in the path of the remote and the player.
•Make sure the remote sensor is not exposed to strong light such as direct sunlight or fluorescent lamp light.
•Move closer to the player when using the remote.
After trying the above remedies, if you still have problems, unplug the mains lead. After all the indications on the display disappear, plug the mains lead in again. If the problem persists, please consult your nearest Sony dealer. In that case, be sure to bring the left speaker which contains the power section along with the main unit (CMT- A50/A70).