(continued)
4 Press TIMER to make the 
indicator and setting display appear.
5 Turn the jog dial to select “REC”, and press the jog dial to enter the selection.
6 Turn the jog dial to select “TUNER” or “LINE”, and press the jog dial to enter the selection.
7 Set the timer to the hour and the minutes you want to start recording.
1Turn the jog dial to set the hour and press it.
2Turn the jog dial to set the minutes and press it.
8 Set the timer to the hour and the minutes you want to stop recording. (Do as step 7.)
9 Turn the jog dial to set the volume you want.
10 Press STANDBY.
The power goes off and the player enters the standby mode. The 
and “REC” indicators appear.
At the preset time, the power will go on and the recording will start. Then the power will go off at the preset time, and the player will enter the standby mode again.
To check/change the recording timer settings
Press TIMER to check the setting.
To change the setting, display the setting you want to change, select the setting item by pressing TUNING + or TUNING – or the jog dial and
To use the player before a timer- recording starts
If you turn on the player, you can use it as usual ( in case of the radio, if you listen to the station which is different from the one you tuned in step 1 on page 35, you will record that station at the preset time.) Turn off the player before the preset time.
Note
You cannot preset recording timer and waking up timer (page 34) at the same time.
Tips
•When you receive the AM program in step 1, press REC to check if the noise is heard. If so, press MODE/DIR to select the position of ISS (Interference Suppress Switch) that most decreases the noise.
•To exit the standby mode, press STANDBY
once to make the
and “REC” indicators disappear.
•The preset settings remain until you reset them.
•When you select both sides recording, the recording will stop after the both sides recording finishes so that accidental recording will not be made.