6Turn on the system.

Press POWER on the unit.

After you press POWER on the unit and turn on the power, you can turn the system on and off by pressing ?/1 on the remote.

Notes

Power remains supplied to the system until you press POWER on the unit again to set it to off.

You cannot operate the system using the remote unless POWER on the unit has been pressed.

When you will not use the system for a long time, press POWER to set it to off.

7Set the color system to PAL or NTSC depending on the color system of your TV.

The color system is factory set to NTSC for region code 3 models, and PAL for other region code models.

Each time you press PAL/NTSC, the color system changes as follows:

NTSC t PAL t Multi t

NTSC (P-Scan) t PAL (P-Scan) t Multi (P-Scan) t NTSC t ...

Notes

A disturbance in the TV screen may be present for a moment after changing the color system as described above.

When you play back a disc recorded in a different color system from the one you set to the unit, the picture image may be distorted.

To set the color system, see page 22.

To connect optional components

See page 34.

Inserting two R6 (size AA) batteries into the remote

Slide and remove the battery compartment lid,

Getting

 

and insert the two supplied R6 (size AA)

 

batteries, E side first, matching the polarities

Started

shown below.

 

e

E E e

Note

If you do not use the remote for a long period of time, remove the batteries to avoid possible damage from battery leakage and corrosion.

Tip

With normal use, the batteries should last for about six months. When the remote no longer operates the system, replace both batteries with new ones.

9GB