Tuner

Presetting radio stations

You can preset up to 30 stations.

1 Press TUNER (TUNER/BAND on the remote) repeatedly to select FM or AM.

2 Press and hold TUNING (TUNING/ CLOCK/TIMER on the remote) + or – until the frequency indication starts to change, then release it.

Scanning stops automatically when the system tunes in a station. “STEREO” (for a stereo program) appears.

If it doesn’t stop automatically, press TUNING (TUNING/CLOCK/TIMER on the remote) + or – repeatedly to tune in a station manually.

3 Press TUNER MEM (TUNER MEM/ ENTER on the remote).

A preset number appears in the display. The stations are stored from preset number 1.

Preset number

4 Press ENTER (TUNER MEM/ENTER on the remote).

The station is stored.

5 Repeat steps 1 to 4 to store other stations.
To tune in a station with a weak signal

Press TUNING (TUNING/CLOCK/TIMER on the remote) + or – repeatedly in step 2 to tune in the station manually.

To set another station to an existing preset number

Start over from step 1. After step 3, press PRESET + or – repeatedly to select the preset number where you want to store the other station and the press ENTER (TUNER MEM/ ENTER on the remote).

You can preset a new station in the selected preset number.

To erase all preset stations

1Press and hold TUNER MEM (TUNER MEM/ENTER on the remote) until “ERASE” and “PRESET” appear alternately.

2Press ENTER (TUNER MEM/ENTER on the remote).

All preset stations are cleared.

To change the AM tuning interval (except for the European model)

Disconnect the power cord from the wall outlet first, and then set the AM FREQ STEP switch at the rear to 9 kHz or 10 kHz.

Tip

The preset stations are retained for half a day even if you unplug the power cord or if a power failure occurs.

10