![](/images/backgrounds/18905/18905-2819x1.png)
To | Do this |
Check the settings | Press CLOCK/TIMER |
| SELECT on the remote, then |
| press ENTER/YES on the |
| remote. “ PLAY ON?” |
| appears, then press ENTER/ |
| YES on the remote. |
|
|
Activate the timer | Press CLOCK/TIMER |
| SELECT on the remote and |
| press .or >on the |
| remote repeatedly until |
| “ PLAY ON?” appears, then |
| press ENTER/YES on the |
| remote. |
|
|
Change the setting | Start over from step 1. |
|
|
Cancel the timer | Press CLOCK/TIMER |
| SELECT on the remote and |
| press .or >on the |
| remote repeatedly until |
| “ TIMER OFF?” appears, then |
| press ENTER/YES on the |
| remote. |
|
|
Notes
•Do not operate the system from the time the system turns on until the play starts (about 15 seconds before the preset time). Otherwise the timer will not be activated correctly.
•If you use the Play Timer at the same time as the Sleep Timer, the Sleep Timer has priority.
•You cannot use the optional components connected to PC/TAPE/MD IN jack as the sound source for Play Timer.
Display
Turning off the display
—Power Saving Mode
Even if the system is off, the system consumes power to display the clock and to stay responsive to commands from the remote. The Power Saving Mode is introduced to reduce the amount of power consumed during standby.
In this mode, the clock is not displayed.
Press DISPLAY while the system is off until the clock display disappears.
To cancel Power Saving Mode
Press DISPLAY while the system is off.
The display changes as follows:
Clock display* y No display (Power Saving Mode)
*The clock is displayed only when you have set the clock.
Tip
The timer continues to operate during Power Saving Mode.
Changing the brightness
for the display
You can change the brightness for the display.
Press DIMMER on the remote repeatedly while the system is on.
The brightness level changes cyclically.
Tip
The brightness level is factory set to high.