Marking track numbers (continued)

To cancel automatic track marking

1Press EDIT on the remote during recording pause.

2Press +/– on the remote repeatedly until “LevelSync ?” appears.

3Press ENTER/YES on the remote. “LevelSyncOFF?” appears.

4Press ENTER/YES on the remote again.

“LEVEL-SYNC” disappears.

When “LEVEL-SYNC” disappears, a track number is marked only at the beginning of each recording.

Notes

•You may not mark track numbers automatically if the sound source to be recorded is noisy (e.g., tapes or radio programs).

•The MD recording is complete only after all the recording information is entered to TOC at which point TOC stops flashing and goes out. Be careful not to disconnect the power cord or move the system before this point. Before disconnecting the power cord, do the following:

–Remove the MD.

–Press 1/u to turn off the system.

Marking track numbers at a specific point while

recording

–– Track Mark

You can mark track numbers at any time while recording, regardless of the type of sound source.

1/u(P p (P p

+

= 0) +

–

–+

6

REC

Press REC while recording at the point you want to add a track mark.

The tracks following the added one are numbered.

Making a space between tracks 3 seconds long

–– Smart Space, Auto Cut

The Smart Space and Auto Cut functions let you make a blank space between tracks three seconds long automatically while making a digital recording.

Smart Space

If there is extended silence of 4 to 29 seconds while digital recording, the system replaces the silence with a blank of about 3 seconds and continues recording.

Auto Cut

If there is no sound input for 30 seconds while digital recording, the system replaces the silence of 30 seconds with a blank of about 3 seconds and enters recording pause.

Notes

•The Smart Space and Auto Cut functions are factory set to ON.

•If you turn the power off or disconnect the power cord, the system will recall the last setting (ON or OFF) of the Smart Space and Auto Cut functions the next time you turn the power on.

•The MD recording is complete only after all the recording information is entered to TOC at which point TOC stops flashing and goes out. Be careful not to disconnect the power cord or move the system before this point. Before disconnecting the power cord, do the following:

–Remove the MD.

–Press 1/u to turn off the system.

36