Recording a CD on an MD (continued)

2 Press CD 6 to open the disc door and place a CD on the disc tray.

With the label side up

3 Press CD 6 to close the disc door.

4 Press CD-MD SYNC.

The MD stands by for recording and the CD pauses at the beginning.

CD

MD

LEVEL- SYNC

 

TRACK

DBFB

 

SYNC

 

C D

- 7 2 m 3 1 s

 

 

 

5 Press MD ^.

Recording starts. When the recording is completed the CD stops and the MD pauses automatically. Press MD p, the MD stops.

To stop recording

Press MD p.

Before inserting an MD

When the power is on, make sure the MD indicator is off. If the MD indicator lights up blue, another MD is already inserted. Press MD 6 and remove the MD.

Tip

The MD is labeled with the disc title of the CD automatically (see page 25) when using a new recordable MD or an MD whose tracks have been completely erased (see page 41) (Disc Memo Copy function).

While “TOC” is lit or is flashing

To ensure complete recording, do not move the system or disconnect the power cord. The system updates the Table of Contents (TOC) while “TOC” is flashing.

If the MD ends during recording

The CD and the MD stop automatically.

Notes

•The MD recording is complete only after all the recording information is entered to TOC at which point TOC stops flashing and goes out. Be careful not to disconnect the power cord or move the system before this point. Before disconnecting the power cord, do the following:

–Remove the MD.

–Press 1/u to turn off the system.

•If the MD is record protected, “MD Protected” appears in the display and the MD cannot be recorded on. Press MD 6 and remove the MD, slide the record protection tab to the closed position (see page 30), reinsert the MD and try again.

•Please do not use MDs with labels that are protruding or labels that have not been positioned correctly. Use of such MDs may damage this system.

16