Listening to audio from a connected component

Listening to a connected MD deck1 Connect the audio cord.

See “Hooking up optional components” on page 14.

2 Press MD (TAPE) (or FUNCTION on the unit) repeatedly until “MD” appears.

Start playing the connected component.

Listening to a connected tape deck

1 Connect the audio cord.

See “Hooking up optional components” on page 14.

2 Press MD (TAPE) (or FUNCTION on the unit) repeatedly until “TAPE” appears.

Hold down FUNCTION on the unit and press ?/1 on the unit. This switches the MD function to TAPE. Once you enable the TAPE function, just press MD (TAPE).

Tip

If you cannot select “MD” by pressing MD (TAPE) (or FUNCTION on the unit) repeatedly, turn off the system and then press ?/1 on the unit while holding down FUNCTION on the unit. The function will change from “TAPE” to “MD”, and “MD” will appear in the display. To change back to “TAPE”, repeat the same procedure. However, you cannot switch the MD/ TAPE function in Power Saving Mode.

Recording on a connected componentMaking an analog recording

1 Connect the audio cord.

See “Hooking up optional components” on page 14.

2 Start recording.

Refer to the operating instructions provided with connected component.

Making a digital recording1 Connect the digital optical cable.

2 Start recording.

Refer to the operating instructions provided with connected component.

Note

You can digitally record from the discs only. However, you cannot record from copy prohibited discs.

Components Optional

15GB