6Press the +/– buttons until the screen color becomes uniform.

Adjust so that the vertical stripes disappear.

7Press the MENU button.

The MENU OSD appears.

If horizontal stripes are observed over the entire screen, adjust the Phase in the next step.

8Press the ˘/³buttons to select PHASE, and press the

MENU button again.

The PHASE OSD appears.

PHASE

MENU

4

9Press the +/– buttons until the screen color becomes uniform.

Adjust until the horizontal stripes are at a minimum.

10When you have finished, click [END] on the screen to turn off the test pattern.

The OSD automatically disappears after about 30 seconds. To close the OSD, press the MENU button twice.

Customizing Your Monitor

Adjusting the Picture Position

If the picture is not in the center of the screen, press the AUTO button. If this operation does not work, adjust the centering as follows.

Once the centering is adjusted, it will be stored in memory for the current input signal.

1Start the Utility Disk and display the test pattern.

Do steps 2 and 3 of “Eliminating Flickering or Blurring Manually.”

2Press the MENU button.

The MENU OSD appears.

MENU

OK MENU

 

MENU

EXIT

 

 

PHASE

 

 

 

 

 

 

PITCH

 

 

 

CENTER

 

 

COLOR

 

GB

 

LANGUAGE

 

OPTION

 

 

3Press the ˘/³buttons to select CENTER, and press the MENU button again.

The CENTER OSD appears.

CENTER

H

MENUV

26

4Move the picture up, down, left, or right until the frame at the perimeter of the test pattern disappears.

For horizontal adjustment, select H using the ˘/³ buttons and adjust the position using the +/–

buttons.

+. . . to move the picture right

– . . . to move the picture left

CENTER

H

V

26

Continued

13