Getting Started

Setup

Before using this monitor, check that the following items are included in your carton:

•LCD monitor (1)

•Rear cover (1)

•Power cord (1)

•AC adapter (1)

•HD15 video signal cable (1)

•Macintosh adapter (1)

•Rubber pads (2)

•Windows Monitor Information Disk/Utility Disk (1)

•Macintosh Utility Disk (1)

•Warranty card (1)

•These operating instructions (1)

Set up

You can set up the monitor on its stand or use it without the stand. The procedure of connecting cables and attaching the rear cover differs depending on how you set up the monitor. In either case, read:

Step 1: Connect the monitor to the computer

Step 2: Connect the power cord

to connect the monitor to the computer and power source. The connection is explained using the stand-type set up for the illustration; however, the connector to be connected and adapter required are the same even when the stand is not used.

Stand set up

Connect the video signal cable and power cord, then attach the rear cover.

Set up without the stand

First detach the stand, and then connect the video signal cable and power cord. Attach the rear cover. The rear cover becomes the stand. See “Using the monitor without the stand” on page 8.

To adjust the angle

The tilt feature allows the

25°

 

monitorto be adjusted within

 

25° upward. To adjust the

 

angle, hold at the bottom

 

and open the stand as

 

illustrated.

 

65°

To adjust the angle

The tilt feature allows the monitor to be adjusted within 65° upward. To adjust the angle, hold at the bottom with both hands as illustrated.

6