Getting Started

• [RGB]: outputs RGB signals.

Note

•If your TV does not accept RGB signals, no picture appears on the TV screen even if you select [RGB]. Refer to the operating instructions supplied with your TV.

10 Press .

The Setup Display for selecting the speaker formation appears.

11 Press C/c to select the speaker formation image as the speakers are actually positioned.

For details, see “Getting Optimal Surround Sound for a Room” (page 76).

SPEAKER FORMATION

STANDARD

12 Press .13 Connect the calibration mic to the A.CAL MIC jack on the front panel.

Set up the calibration mic at the ear level using a tripod, etc. (not supplied). The front of each speaker should face the calibration mic, and there should be no obstruction between the speakers and the calibration mic.

Calibration mic

14 Press C/c to select [YES].

Note

•Make sure that the headphones are not connected to the unit or surround amplifier. You cannot operate following Steps with the headphones connected.

15 Press.

[AUTO CALIBRATION] starts. Be quiet during the measurement.

Note

•Loud test sound is output when [AUTO CALIBRATION] starts. You cannot turn the volume down. Give consideration to children and neighbors.

•Before [AUTO CALIBRATION], install the surround amplifier in the appropriate location. If you install the surround amplifier in an improper location, such as another room, proper measurement will not be obtained.

•Avoid being in the measurement area and making noise during the measurement (which takes about 3 minutes), as it may interfere with measurement.

22GB