Calibrating the

Appropriate Settings

Automatically

[AUTO CALIBRATION]

D. C. A. C. (Digital Cinema Auto Calibration) can set the appropriate surround sound automatically.

Note

•The system outputs a loud test sound when [AUTO CALIBRATION] starts. You cannot turn the volume down. Give consideration to children and neighbors.

•Make sure that the headphones are not connected to the unit or surround amplifier. You cannot operate the following Steps with the headphones connected.

1 Press FUNCTION +/– repeatedly until

“DVD” appears in the front panel display.

2 Press DISPLAY while the system is in stop mode.

The Control Menu display appears on the TV screen.

3 Press X/x to select [SETUP], then press .

The options for [SETUP] appear.

4 Press X/x to select [CUSTOM], then press .

The Setup Display appears.

5 Press X/x to select [AUDIO SETUP], then press .

The options for [AUDIO SETUP] appear.

6 Press X/x to select [AUTO

CALIBRATION], then press .

The options for [AUTO CALIBRATION] appear.

7 Connect the calibration mic (supplied)

to the A.CAL MIC jack on the front panel

Set up the calibration mic at the ear level using a tripod, etc. (not supplied).

The front of each speaker should face the calibration mic, and there should be no

obstruction between the speakers and the calibration mic.

Calibration mic

Operations Other

8 Press C/c to select [YES].

9 Press.

[AUTO CALIBRATION] starts. Be quiet during the measurement.

Note

•Before [AUTO CALIBRATION], make sure that the surround amplifier turns on and you install the surround amplifier in the appropriate location. If you install the surround amplifier in an improper location, such as another room, proper measurement will not be obtained.

•Avoid being in the measurement area and making noise during the measurement (about 3 minute), to avoid measurement failure. During the measurement, test signals are output from the speakers.

•The environment of the room in which the system is installed may affect measurements.

•If an error message appears, follow the message, then select [YES].

An error message appears when:

77GB