USB device

Symptom

Remedy

“OVERLOAD” appears in the

• A problem has been detected with the level of electrical current from the

front panel display.

(USB) port. Turn off the system and remove the USB device from the

 

(USB) port. Make sure there is no problem with the USB device. If this display

 

pattern persists, contact your nearest Sony dealer.

 

 

Are you using a supported USB

• If you connect an unsupported USB device, the following problems may occur.

device?

See “Playable USB Devices” (supplement) for the supported device types.

 

– The USB device is not recognized.

 

– File or folder names are not displayed on this system.

 

– Playback is not possible.

 

– The sound skips.

 

– There is noise.

 

– A distorted sound is output.

 

– Recording stops before it is finished.

 

 

There is no sound.

• The USB device is not connected correctly. Turn off the system, then reconnect

 

the USB device.

 

 

The sound is distorted.

• The bit rate used when encoding the audio files was low. Send audio files

 

encoded with higher bit rates to the USB device.

There is noise or the sound skips. • Turn off the system, then reconnect the USB device.

•Noise may have entered during the recording or copying process. Delete the file, and try recording or copying again.

•Copy the files to your computer, format the USB device in FAT12, FAT16, or FAT32 format, and copy the files to the USB device again.*

*This system supports FAT12, FAT16, and FAT32, but some USB device may not support all of these FAT. For details, refer to the operating instructions of each USB device or contact the manufacturer.

The USB device cannot be

• The USB device is being connected backwards. Connect the USB device in the

connected into the

(USB)

correct orientation.

port.

 

 

 

 

The USB device which has been

• It may be recorded in an unsupported format. If so, first take the precaution of

used on another device does not

backing up important files on the USB device by copying them to your

work.

 

computer hard disk. Next, format the USB device with a FAT12, FAT16, or

 

 

FAT32 file system and transfer the backed-up audio files onto the USB device

 

 

again.*

 

* This system supports FAT12, FAT16, and FAT32, but some USB device may

 

not support all of these FAT. For details, refer to the operating instructions of

 

each USB device or contact the manufacturer.

 

“READING” is displayed for a • The reading process can take a long time in the following cases.

long time.

– There are many folders or files on the USB device.

 

– The file structure is extremely complex.

 

– The memory capacity is excessive.

 

– The internal memory is fragmented.

 

• Sony recommends following these guidelines.

 

– Total folders on the USB device: 200 or less

 

– Total files per folder: 150 or less

 

 

Erroneous display.

• Send the music data to the USB device again, as the data stored in the USB

 

device may have been corrupted.

• The character codes that can be displayed by this system are numbers and alphabet only. Other characters are not displayed correctly.

Information Additional

91GB