Sony DAV-LF1H 30GB, 8 Press, 10 Press, 12 Press X/x to select [YES], then press, 9 Press X/x to select the output method for video signals

Getting Started – BASIC –

8 Press .

The Setup Display for selecting the output method for video signals from the EURO AV T OUTPUT (TO TV) jack appears.

SCREEN SETUP

TV TYPE:	16:9
HDMI RESOLUTION:	AUTO
YCBCR/RGB (HDMI):	YCBCR
SCREEN SAVER:	ON
BACKGROUND:	JACKET PICTURE
LINE:	VIDEO
4:3 OUTPUT:	VIDEO
	RGB

9 Press X/x to select the output method for video signals.

•[VIDEO]: outputs video signals.

•[RGB]: outputs RGB signals.

Note

•If your TV does not accept RGB signals, no picture appears on the TV screen even if you select [RGB]. Refer to the instructions supplied with your TV.

10 Press .

The [AUTO CALIBRATION] display appears.

AUTO CALIBRATION

Connect calibration mic. Start measurement?

YES

NO

11 Connect the calibration mic to the ECM-AC1 jack on the rear of the subwoofer and set up the calibration mic at the ear level using a tripod, etc. (not supplied).

The front of each speaker should face the calibration mic, and there should be no obstruction between the speakers and the calibration mic.

ECM-AC1	VIDEO 1	VIDEO 2	TV	VIDEO 1
	AUDIO IN	AUDIO IN	DIGITAL IN	DIGITAL IN
				COAXIAL
			L

	OPTOCAL	VIDEO 2
R		DIGITAL
		IN
		COAXIAL

Rear of the subwoofer

Calibration mic

Note

•Place the calibration mic so that the “FRONT” side of it is pointed toward the front speakers.

12 Press X/x to select [YES], then press

.

[AUTO CALIBRATION] starts. Be quiet during the measurement.

Note

•Loud test sound is output when [AUTO CALIBRATION] starts. You cannot turn the volume down. Give consideration to children and neighbor.

•Avoid being in the measurement area and making noise during the measurement (which takes about 1 minute), as it may interfere with measurement.

•If the sound of the surround speakers is not output, adjust the wireless system. See “Adjusting the IR transmitter and IR receiver of the surround speaker (L)” (page 28).

30GB