Connecting your camcorder to your computer – Introduction

If you cannot install the USB driver

The USB driver has been registered incorrectly as your computer was connected to your camcorder before the installation of the USB driver was completed. Perform the following procedure to install the USB driver correctly.

1Disconnect your camcorder from the computer following “To disconnect the

USB cable” (page 97).

2Install the USB driver again following

“Installing the USB driver” (page 92).

3After “InstallShield Wizard complete”

dialog box disappears, restart your computer.

4Connect your camcorder to the computer following “Connecting your camcorder to the computer” (page 94). The USB driver installation and the connection between your camcorder and the computer is completed.

Consulting the on-line help

An ImageMixer on-line help is available where you can find detailed operating instructions for ImageMixer software.

1 Click located at the top right of the window.

Or, click [Start] t [Programs] ([All Programs] in Windows XP) t [PIXELA] t [ImageMixer] t [Help]. The ImageMixer Help window appears.

2 Find the information you need from the table of contents.

To close the on-line help

Click the button at the top right of the window.

If you have any questions about ImageMixer

ImageMixer is a product of PIXELA Corporation. For details, refer to the operating instructions of the CD-ROM supplied with your camcorder.

98