Sony DCR-HC85E manual 99

Manufacturing	[IR SETUP] code
company
Roadstar	47
SABA	21, 76, 91
Salora	89
Samsung	22, 32, 52, 93, 94
Sanyo	36
Schneider	10, 83, 84
SEG	73
Seleco	47, 74
Sharp	89
Siemens	10, 36
Tandberg	26
Telefunken	91, 92
Thomson	76, 100
Thorn	36, 47
Toshiba	40, 93
Universum	47, 70, 84, 92
W. W. House	47
Watoson	58, 83

* TV/VCR component

Step 2 : Adjusting the synchronization of the VCR

Follow the steps below when you are performing digital program edit for the first time to a tape in a VCR. You can skip this setting if you have set up your VCR before using the following procedure.

You can adjust the synchronization of your camcorder and the VCR to avoid not recording the starting scene.

1 Remove the cassette from your camcorder. Prepare a pen and paper to take notes.

2 Set the VCR to recording pause mode.

Skip this step if you have selected [i.LINK] in step 11 on p. 97.

bNote

•Run the tape for about 10 seconds before pausing. The starting scenes may not get recorded when you start recording from the beginning of the tape.

3 Touch				, then [ADJ TEST].
	PROG. EDIT			0:00:00:00
	ADJ TEST
		Set the recording
			device in
		rec. pause mode.
		EXEC		CANCEL
4 Touch [EXEC].
	A picture (about 50 seconds long) with 5
	[IN] and [OUT] indicators each for
	adjusting synchronization is recorded.
	[Completed.] appears when the recording is
					Dubbing/Editing
	finished.
	PROG. EDIT			0:00:00:00
	ADJ TEST
		Completed.

5 Rewind the tape on your VCR, then play back in slow mode.

5 opening numbers for each [IN] and closing numbers for each [OUT] appear.

6 Take a note of the opening number value of each [CUT-IN] and the closing number value of each [CUT-OUT], then calculate the average number value for each [CUT-IN] and [CUT- OUT].

,continued

Dubbing/Editing 99