To charge the
Your camcorder has a
Procedures
Connect your camcorder to a wall outlet using the supplied AC Adaptor, and leave it with the POWER switch set to OFF (CHG) for more than 24 hours.
To change the battery of the Remote Commander
While pressing on the tab, inset your fingernail into the slit to pull out the battery case.
Place a new battery with the + side facing up.
Insert the battery case back into the Remote Commander until it clicks.
Tab
WARNING
Battery may explode if mistreated. Do not recharge, disassemble or dispose of in fire.
Caution
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer.
Discard used batteries according to the manufacturer’s instructions.
•A
•When the lithium battery becomes weak, the operating distance of the Remote Commander may shorten, or the Remote Commander may not function properly. In this case, replace the battery with a Sony CR2025 lithium battery. Use of another battery may present a risk of fire or explosion.
Information Additional
113