Dubbing/Editing

Symptom

Cause and/or Corrective Actions

 

 

Pictures from connected devices are not displayed on the LCD screen or the viewfinder.

cSet [DISPLAY] to [LCD PANEL] in the (STANDARD SET) menu. (p. 82)

Still pictures cannot be dubbed from a

• You cannot record or a distorted picture may be recorded if the tape has

tape to a “Memory Stick.”

been used repeatedly for recording.

 

 

 

 

 

Movies cannot be dubbed from a tape

• You cannot record or a distorted picture may be recorded in the

to a “Memory Stick.”

following:

 

 

– The tape has a blank section.

 

 

– The tape has been used repeatedly for recording.

 

– Input signal has been interrupted or cut.

 

 

 

 

Digital program editing on the tape

cSet the input selector on the VCR correctly, then check the connection

does not function.

between your camcorder and the VCR. (p. 87)

 

cWhen your camcorder is connected to a DV device that is not a Sony

 

product via an i.LINK cable, select [IR] in step11 of “Step 1: Preparing

 

your camcorder and VCR for operation” (p. 92).

 

cAdjust the synchronization of the VCR. (p. 95)

 

cEnter a correct [IR SETUP] code. (p. 94)

 

 

cSelect the mode used to cancel recording pause again. (p. 94)

 

cSet your camcorder and the VCR more than 30 cm (12 in.) apart. (p. 94)

 

cSet [PB MODE] to [AUTO] in the

 

 

(STANDARD SET) menu.

 

 

 

 

 

 

(p. 80)

 

• The program may not be set to a blank section on the tape.

• You cannot perform the Digital program editing on a VCR that does not support [IR SETUP] codes, a DVD recorder and a DVD recorder equipped with an HDD, etc.

The VCR is not responding properly during Digital program editing when it is connected via an i.LINK cable.

•While connecting via an i.LINK cable, select [IR] in step 11 of “Step 1: Preparing your camcorder and VCR for operation” (p. 92).

•You cannot perform the Digital program editing on a DVD recorder, a DVD recorder equipped with an HDD, etc.

Digital program editing on the “Memory Stick” does not function correctly.

•The program may not be set to a blank section on the tape.

•You cannot record or a distorted picture may be recorded if the tape has been used repeatedly for recording.

122Troubleshooting