
Replacing recording on a tape – insert editing
You can insert a new scene from a VCR onto your originally recorded tape by specifying starting and ending points. After inserting editing, the previous picture and sound will be erased.
Connection is the same as on page 59. In recording and recording pause mode, DV IN/OUT jack automatically works as input jack.
You can only operate with the Remote Commander.
(1) While pressing the small green button on the POWER switch, set it to VTR.
(2) On the VCR, locate the start point to be inserted and set it to playback pause mode.
(3) On the camcorder, press (to set it to playback mode, and then locate the point where the insert should end by pressing 0or ). Then press Pto set it to playback pause mode.
(4) Press ZERO SET MEMORY on the Remote Commander. The ZERO SET MEMORY indicator flashes and the end point of the insert is stored in memory.
(5) On the camcorder, locate the point where the insert should begin by pressing 0, then press rREC on the Remote Commander to set it to recording pause mode.
(6) Press Pon the camcorder and the VCR simultaneously to start insert editing.
The insert editing stops automatically near the counter’s zero point. Press pto set the camcorder to stop mode.
To change the end point
Press ZERO SET MEMORY on the Remote Commander so that the ZERO SET MEMORY indicator disappears and begin from step 3.
Note on the inserted picture
The picture may be distorted at the end of the inserted portion when it is played back.
operations Advanced
61