
Trouble check
If you run into any problem using the camcorder, use the following table to troubleshoot the problem. Should the difficulty persist, disconnect the power source and contact your Sony dealer or local authorized Sony service facility.
Camcorder
Power
Symptom | Cause and/or corrective actions |
The power is not on. | • The battery pack is not installed. |
| mInstall the battery pack. (p. 10) |
| • The battery is dead. |
| mUse a charged battery pack. (p. 7) |
| • The AC power adaptor is not connected to a wall outlet. |
| mConnect the AC power adaptor to a wall outlet. (p. 22) |
The power goes off. | • While being operated in CAMERA mode, the camcorder |
| has been in Standby mode for more than 5 minutes. |
| mSet the POWER switch to OFF, then to CAMERA. (p. 11) |
| • The battery is dead. |
| mUse a charged battery pack. (p. 7) |
The battery pack is quickly | • The ambient temperature is too low. (p. 68) |
discharged. | • The battery pack has not been charged fully. |
| mCharge the battery pack again. (p. 7) |
| • The battery pack is completely dead, and cannot be |
| recharged. |
| mUse another battery pack. (p. 22) |
Operation
Symptom | Cause and/or corrective actions |
START/STOP does not operate. | • The tape is stuck to the drum. |
| mEject the cassette. (p. 10) |
| • The tape has run out. |
| mRewind the tape or use a new one. (p. 19) |
| • The POWER switch is set to VTR. |
| mSet it to CAMERA. (p. 11) |
| • The tab on the cassette is out (red). |
| mUse a new tape or slide the tab. (p. 10) |
The cassette cannot be removed from | • The battery is dead. |
the holder. | mUse a charged battery pack or the AC power adaptor. |
| (p. 7, 22) |
{and 6indicators flash and no | • Moisture condensation has occurred. |
function except for cassette ejection | mRemove the cassette and leave the camcorder for at least |
works. | 1 hour. (p. 71) |
|
|
“CLOCK SET” appears when the | • Reset the date and time. (p. 66) |
camcorder is turned on. |
|
|
|
The End Search function does not | • You did not make a new recording after reinserting the |
activate. | cassette. |
| • The tape without cassette memory ejected after recording. |
| Continued to the next page |
information Additional
75