Charging and installing the battery pack
Notes on charging the battery pack
•The CHARGE lamp will remain lit for a while even if the battery pack is removed and the power cord is unplugged after charging the battery pack. This is normal.
•If the CHARGE lamp does not light, disconnect the power cord. After about one minute, reconnect the power cord again.
•You cannot charge the battery pack while you operate the camcorder using the AC power adaptor.
•When a fully charged battery pack is installed, the CHARGE lamp will light once, then go out.
Installing the battery pack
(1) Lift up the viewfinder.
(2) Insert the battery pack in the direction of the $mark on the battery pack. Slide the battery pack down until it is locked.
Attach the battery pack to the camcorder securely.
1 
2
Note on installing the
Use the camcoder while stretching out the viewfinder. Be careful not to catch your finger in when you fold the viewfinder back to the original position.
Note on installing the
Use the camcorder while lifting up the viewfinder.
When you install the viewfinder adaptor, you can record a picture with stretching out the viewfinder while using the
Install the viewfinder adaptor by matching the adaptor groove and the finder tip shown in the figure. An eclipse may appear in the finder if you use the adaptor. This will not affect the recorded image.
Note on the battery pack
Do not carry the camcorder by grasping the battery pack.
To remove the battery pack [b]
While pressing BATT, slide the battery pack in the direction of the arrow.
[a] | Viewfinder adaptor | [b] |
BATT
started Getting
You can look at the demonstration of the functions available with this camcorder (p. 26). | 9 |
|