5-17
ROUTING SWITCHER SYSTEM (E)
5-1. Setting Items of the Primary Station
8. Select the number of net group with cursor keys and
press [Enter] to set the input mode.
Set the signal path between two routing switchers,
using the combination of the
“OUT of the front stage” > “IN of the latter stage”.
9. Input the source number and the destination number
with the numerical keys and press [Enter] to set it.
When change the level, move the cursor to the level
and press [Enter].
10. Press [F1] to move the cursor to the tie line path
setting screen.
Set tie line paths using the combination of
“Source group” _ “Net group” _ “Net group” _
“Destination group”.
The two “Net groups” can be set at a maximum.
However, leave one “Net group” blank when there are
two routing switchers to be connected.
11. Move the cursor to a path number and press [Enter].
The source group input mode will be set.
12. Input the source group number and press [Enter]. The
cursor will move to the net group. Input the net group
and destination group in the same way as for the
source group. Up to two net groups can be input for
one path.
13. Use the above procedure to assign the source, destina-
tion and net numbers to each path number.
Operating Function Keys
[F1] : MOVE
When [F1] is pressed, the cursor will move be-
tween upper and lower of the screen.
[F2] : JUMP (To move the cursor to the group number of
the desired source)
1. When [F2] is pressed, “Please Input
GROUP NUMBER =” will be displayed.
2. Input the group number of the source to be
retrieved.
3. When [Enter] is pressed, the cursor will move
to the desired number.
[F3] : Pg Up
When [F3] is pressed, the top half of the screen will
display the 6 lines previous to the 6 lines displayed
currently.
[F4] : Pg Dn
When [F4] is pressed, the top half of the screen will
display the 6 lines next to the 6 lines displayed
currently.
[F5] : GROUP
(To move the cursor to the top half of the screen
and press [F5]. The display will change: “Source
Gp” → “Destination Gp” → “Net Gp”.)
[F5] : DISP
(To move the cursor to the bottom half of the screen
and press [F5]. The display will change : “Path” →
“Source Name” → “Destination Name”.)