To interrupt, touch [REC STOP] in step . To resume, touch [REC START].
To cancel, touch [REC STOP], then [END].
•When your camcorder has shot several frames, it records them on the tape, after performing the END SEARCH function depending on the interval length.
•Do not turn off the power or disconnect the power source while a message is displayed on the screen.
•The camcorder will shoot several frames for the first and last shots of the Smooth interval recording.
•Smooth interval recording is released when approximately 12 hours have elapsed after shooting has begun.
•Sounds are not recorded.
•The last few frames may not be recorded if the battery or tape has run out.
•There may be discrepancies in the interval.
•If you adjust the focus manually, you can record clear pictures even if the light changes ([FOCUS], p. 42).
•You can silence the beeps during recording.
You can record still images on the “Memory Stick Duo” at a selected interval. This function is useful to observe the movement of clouds or the changes in daylight, etc.
[a]: Recording
[b]: Interval
Touch 
a desired interval time (1, 5 or 10 minutes) 
[ON] 
.
Press PHOTO fully.
stops flashing and the interval still image recording starts.
To cancel
The default setting is [ON], allowing you to view the demonstration in about 10 minutes, after you have removed both a cassette and a “Memory Stick Duo” from your camcorder, and slide the POWER switch down to turn on the CAMERA- TAPE lamp.
•The demonstration will be suspended in situations such as those described below.
–When you touch the screen during the demonstration. (The demonstration starts again in about 10 minutes.)
–When a cassette or a “Memory Stick Duo” is inserted.
–When the POWER switch is set to other than
–When NIGHTSHOT PLUS switch is set to ON.
PRINTSee page 67.
Menu the Using
51