Self-diagnosis display/Warning Indicators

The recording stops.

The temperature of your camcorder is extremely high/low. Turn off your camcorder and leave it for a while in a cool/warm place.

”PMB” cannot be installed.

Check the computer environment or installation procedure required to install “PMB” (p. 36).

”PMB” does not work correctly.

Quit “PMB” and restart your computer.

The camcorder is not recognized by the computer.

Disconnect devices from the USB jack of the computer other than the keyboard, mouse, and your camcorder.

Disconnect the USB cable from the computer and your camcorder, and restart the computer, then connect the computer and your camcorder again in an orderly manner.

Self-diagnosis display/Warning

indicators

If indicators appear on the LCD screen, check the following.

If the problem persists even after you have tried to fix a couple of times, contact your Sony dealer or local authorized Sony service facility. In this case, when you contact them, give them all the numbers of the error code beginning with C or E.

C:04:

The battery pack is not an “InfoLITHIUM” battery pack V series. Use an “InfoLITHIUM” battery pack (V series) (p. 15).

Connect the DC plug of the AC Adaptor to your camcorder securely (p. 15).

C:06:

The battery pack temperature is high. Change the battery pack or place it in a cool place.

C:13: / C:32:

Remove the power source. Reconnect it and operate your camcorder again.

E::

Follow the steps from to on page 64.

The internal hard disk of your camcorder is full. Delete unnecessary images on the internal hard disk (p. 34).

An error may have occurred with the internal hard disk of your camcorder.

Battery power is low.