Sony HTSF2300, HT-SS2300 When error codes appear, 28), Tips, SAVE, Item, SAVE, EXIT, 28GB, ERROR, RETRY, PHASE, LEVEL, result, process, process, When the, properly, When the, WARN CHK

Tips

•When Auto Calibration starts:

–Stand some distance from the speakers and the listening position to avoid measurement failure. This is because test signals are output from the speakers during measurement.

–Avoid making noise to get a more accurate measurement.

•The Auto Calibration function will be canceled when you do the following during the measurement process:

–Press ?/1 or MUTING.–Press input buttons on the remote or INPUT SELECTOR on the receiver.–Change the volume level.–Press AUTO CAL again.Confirming/saving the measurement results1 Confirm the measurement result.

When the measurement ends, a beep sounds and the measurement result appears on the display.

Measurement Display		Explanation
result
When the	SAVE	Proceed to step
measurement		2.
process
completes
properly
When the	ERROR	See “When
measurement	XXXX	error codes
process fails		appear” (page
		28).

2 Press V/v repeatedly to select the item. Then, press .

Item	Explanation
RETRY	Performs the Auto
	Calibration again.
SAVE	Saves the measurement
	results and exits the setting
	process.
WARN CHK	Displays warning
	concerning the
	measurement results. See
	“When you select “WARN
	CHK”” (page 29).
PHASE	Displays the phase of each
	speaker (in phase/out of
	phase). See “When you
	select “PHASE”” (page 29).
DISTANCE	Displays the measurement
	result for speaker distance.
LEVEL	Displays the measurement
	result for speaker level.
EXIT	Exits the setting process
	without saving the
	measurement results.

3 Save the measurement result.Select “SAVE” in step 2.The measurement results are saved.

When error codes appear

Try the remedies and perform the Auto Calibration again.Error code Cause and remedies

ERROR 32 None of the speakers were detected. Make sure that the optimizer microphone is connected properly and perform the Auto Calibration again.

If the optimizer microphone is connected properly but the error code appears, the optimizer microphone cable may be damaged or improperly connected.

ERROR F 33 • None of the front speakers are connected or only one front speaker is connected.

•The optimizer microphone is not connected.

28GB