The control for HDMI function does not work.

•Check the HDMI connection (page 20).

•Make sure “CONTROL FOR HDMI” is set to “CTRL ON” in VIDEO menu.

•Make sure the connected component is compatible with the Control for HDMI function.

•Check the Control for HDMI settings on the connected component. Refer to the operating instructions of the connected component.

•Repeat the procedures of “Preparing Control for HDMI function” if you change the HDMI connection, connect/disconnect the AC power cord, or there is a power failure (page 56).

No sound is output from the receiver and TV speaker while using the System Audio Control function.

•Make sure the TV is compatible with the System Audio Control function.

•If the TV does not have System Audio Control function, set the “AUDIO FOR HDMI” settings in VIDEO menu to

–“TV+AMP” if you want to listen to the sound from the TV speaker and receiver.–“AMP” if you want to listen to the sound from the receiver.•If you cannot listen to the sound of a component connected to the receiver

–Select the appropriate input when you want to watch a program on a component connected via HDMI connection to the receiver.

–Change the TV channel when you want to watch a TV broadcast.

–Select the component or input you want to watch when you watch a program on the component connected to the TV.

Refer to the operating instructions of the TV on this operation.

Tuner

The FM reception is poor.

•Use a 75-ohm coaxial cable (not supplied) to connect the receiver to an outdoor FM antenna as shown below. If you connect the receiver to an outdoor antenna, ground it against lightning. To prevent a gas explosion, do not connect the ground wire to a gas pipe.

Outdoor FM antenna

Receiver

AM

Ground wire (not supplied)

ANTENNA

To ground

Radio stations cannot be tuned in.

•Check that the antennas are connected securely. Adjust the antennas and connect an external antenna, if necessary.

•The signal strength of the stations is too weak (when tuning in with automatic tuning). Use direct tuning (page 50).

•Make sure you set the tuning interval correctly (when tuning in AM stations with direct tuning).

•No stations have been preset or the preset stations have been cleared (when tuning by scanning preset stations). Preset the stations (page 50).

RDS does not work.a)•Make sure that you are tuned to an FM RDS station.•Select a stronger FM station.
Information Additional

continued

69GB