Sony HTSF2300, HT-SS2300 To rectify the error, When you select “WARN CHK”, When you select “PHASE”, Tip, WARN, WARN, 29GB, xx* IN, Center, NO WARN, Display, xx* OUT, Subwoofer

Error code Cause and remedies

ERROR SR 33 Either the left or right surround speaker is not connected.

ERROR SW 33 Subwoofer is not connected. Connect the subwoofer to the SUBWOOFER terminal.

ERROR 33 Wrong speaker detection due to noise. Make sure the environment is quiet during Auto Calibration.

ERROR 35 A sound similar to the beep sound from the speakers while performing Auto Calibration is detected. Perform the Auto Calibration again.

To rectify the error

1Record down the error code.2Press , “RETRY Y” appears on the display.3Rectify the error.For details, see “When error codes appear” above.4Press to perform Auto Calibration again.

When you select “WARN CHK”

If a warning on the measurement result is present, detailed information is displayed.

Press to return to step 2 of “Confirming/saving the measurement results”.Warning code Explanation

WARN 40 The Auto Calibration has completed. However, the noise level is high. You may be able to perform the Auto Calibration properly if you try it again, even though the measurement cannot be performed in all environments. Try to perform the Auto Calibration in a quiet environment.

Warning code Explanation

WARN 41 The sound input from the optimizer microphone is out of the acceptable range. It is louder than the loudest sound that can be measured. Try to perform the Auto Calibration when the environment is quiet enough to allow proper measurement.

WARN 42	The volume of the receiver is out
	of the acceptable range. Try to
	perform the Auto Calibration
	when the environment is quiet
	enough to allow proper
	measurement.
WARN 43	The distance and position of a
	subwoofer cannot be detected.
	This may be caused by noise. Try
	to perform the Auto Calibration
	in a quiet environment.
NO WARN	There is no warning information.

When you select “PHASE”

You can check the phase of each speaker (in phase/out of phase).Press V/v repeatedly to select a

speaker, then press			to return to
step 2 in “Confirming/saving the
measurement results”.
Display		Explanation
xx* IN		The speaker is in phase.
xx* OUT		The speaker is out of phase. The
		“+” and “–” terminals of the
		speaker may be connected the
		other way around.
* xx represent a speaker channel
FL	Front left
FR	Front right
C	Center
SL	Surround left
SR	Surround right
SW	Subwoofer

Tip

Depending on the position of the subwoofer, the measurement results for polarity may vary. However, there will be no problems even if you continue to use the receiver with that value.

continued

Started Getting

29GB