Viewing pictures from connected equipment

Switch on the connected equipment, then perform one of the following operation.

For equipment connected to the scart sockets using a fully-wired 21-pin scart lead

Start playback on the connected equipment.

The picture from the connected equipment appears on the screen.

For an auto-tuned VCR (page 4)

In analogue mode, press PROG +/-, or the number buttons, to select the video channel.

For other connected equipment

Press / repeatedly until the correct input symbol (see below) appears on the screen.

AV1/ AV1, AV2/ AV2: Audio/video or RGB input signal through the scart

socket / 1 or 2. appears only if an RGB source has been connected.

AV3:

Component input signal through the Y, PB/CB, PR/CR

sockets /3, and audio input signal through the

L, R sockets /3.

AV4/AV4:

Video input signal through the video socket 4, and audio input signal through the L (MONO), R audio

sockets 4. appears only if the equipment is

connected to the S video socket 4 instead of the

video socket 4, and S video input signal is input

through the S video socket 4.

5:

RGB input signal through the PC connectors 5, and audio input signal through the socket .

AV6/ AV7:

Digital audio/video signal is input through the HDMI IN 6 socket. Audio input signal is analogue only if the equipment has been connected using the DVI and audio out socket.

Additional operations

To

Do this

Return to the normal Press DIGITAL or ANALOG. TV operation

To

Do this

 

 

 

 

 

Access the Input

Press

to access the Input signal

signal index table

index table. (Then, only in

 

analogue mode, press g.) To

 

select an input source, press F/f,

 

then press

.

 

 

 

 

18 GB