Viewing pictures from connected equipment

Switch on the connected equipment, then perform one of the following operation.

For equipment connected to the scart sockets using a fully-wired 21-pin scart lead

Start playback on the connected equipment.

The picture from the connected equipment appears on the screen.

For an auto-tuned VCR (page 11)

In analogue mode, press PROG +/-, or the number buttons, to select the video channel.

For other connected equipment

Press / repeatedly until the correct input symbol (see below) appears on the screen.

1/ 1, 2/ 2:

Audio/video or RGB input signal through the scart

socket / 1 or 2. appears only if an RGB source has been connected.

3:

Component input signal through the Y, PB/CB, PR/CR

sockets /3, and audio input signal through the

L/G/S/I, R/D/D/D sockets / 3.

4:

Digital audio/video signal is input through the HDMI IN 4 socket. Audio input signal is analogue only if the equipment has been connected using the DVI and audio out socket.

5/5:

Video input signal through the video socket 6, and audio input signal through the audio socket L/G/S/I

(MONO), R/D/D/D sockets 5. appears only if

the equipment is connected to the S video socket 5

instead of the video socket 5, and S video input

signal is input through the S video socket 5.

Additional operations

To

Do this

Return to the normal Press DIGITAL or ANALOG. TV operation

Access the Input

Press OK to access the Input signal

signal index table

index table. (Then, only in

 

analogue mode, press ,.) To

 

select an input source, press M/m,

 

then press OK.

 

 

Using the Menu
Navigating through menus2,3,4

4

1

1 Press MENU to display the menu.

2 Press M/m to select a menu icon.

3 Press M/m/</, to select an option.

4 Press M/m/</, to change/set the setting, then press OK.

To exit the menu, press MENU.

To return to the last display, press <.

Continued

Menu the Using
21 GB