✍ You cannot record signals from equipment connected to the Y, PB, PR input.
You may need to change the video input on your VCR. Consult your VCR’s operating manual for instructions.
To perform tape editing, set the projection TV to the video input intended for playback by pressing TV/VIDEO on the remote control.
✍
✍
✍ If your VCRs have an S VIDEO jack: For best picture quality, use an
S VIDEO connection instead of the yellow video cable on your combined A/V cable.
Using an S VIDEO cable, connect the playback VCR’s S VIDEO OUT jack to the recording VCR’s S VIDEO IN jack. S VIDEO does not provide audio, so audio cables must be connected to provide sound.
Installing and Connecting the Projection TV
Connecting Two VCRs for Tape Editing
If you connect two VCRs, you can record from one VCR to the other while using your projection TV to monitor what is being recorded.
Disconnect all power sources before making any connections.
1 Using AUDIO and VIDEO cables, connect the playback VCR’s Audio and Video OUT jacks to the recording VCR’s Audio and Video IN jacks.
2 Using AUDIO and VIDEO cables, connect the recording VCR’s AUDIO and Video OUT jacks to the projection TV’s AUDIO and VIDEO IN jacks.
Rear of projection TV
VCR (playback) | VCR (recording) |
VIDEO (yellow) |
22
