ProblemCause/Remedy
The remote does not function • Check that the remote is set correctly for the equipment you are using.
•Check whether the equipment you want to use corresponds to the function button being pressed (page 13).
•If the remote does not operate the equipment even when the remote has been set correctly to the equipment, enter the necessary code as explained in “Programing the remote” (page 37).
•Replace the batteries.
indicator flashes in red | • | After waiting several minutes, try switching the TV on by pressing "/1 on |
|
| the remote or 1 on the TV. |
| • | Replace the lamp (page 39). |
The TV does not switch on • The TV cools down its projection lamp after being switched off. It takes up to two minutes for the picture to come back after the TV is switched on again. Wait for a while until the picture returns.
•If the high temperature warning message appears, switch off the TV and wait until the TV’s projection lamp cools down (approximately 5 minutes). If the remote control still does not work, make sure to dust the ventilation slots on the rear of the TV and the cooling fan to provide adequate ventilation around the TV.
Cannot play shooting games • Some shooting games that involve pointing a light beam at the TV screen with an electronic gun or rifle cannot be used with your TV. For details, see the instruction manual supplied with the video game software.
On/standby indicator flashes in • Three blinks: The lamp cover or the lamp itself is not securely attached.
intervals of some blinks at a • Two blinks: If there is a considerable rise in temperature inside the TV such
timeas when any ventilation openings are blocked.
• Other: Consult your dealer or service.
A slight creaking noise occurs • Advanced Iris applies a mechanical iris system. When Advanced Iris is
from the bottom part of the TV turned On/Off, a natural creaking noise occurs due to the basic structure of the optical unit. The creaking sound is an inherent nature of this system and is not a defect.
High temperature warning • This message will appear when there is a rise in temperature inside the TV.
message appearsMake sure to remove dust from the ventilation slots on the rear and both sides of the TV. In addition, make sure that there are no obstacles in front of the ventilation slots. If no blockage is found, you may need to set Cooling Mode to “High”, otherwise the TV will turn off. With Cooling Mode set to “High”, if the message reappears and the TV turns off again, the TV may need servicing. Call your local Sony service center.