To connect

Do this

 

 

Digital receiver or

Connect to the HDMI IN 1 or 2

DVD player D

jack if the equipment has an

 

HDMI jack. The digital video and

 

audio signals are input from the

 

equipment. If the equipment has a

 

DVI jack, connect the DVI jack to

 

the HDMI IN 2 jack through a DVI

 

- HDMI adaptor interface (not

 

supplied), and connect the

 

equipment’s audio out jacks to the

 

audio in the HDMI IN 2 jacks.

Notes

•The HDMI jacks only support the following video inputs: 480i, 480p, 576i, 576p, 720p, 1080i and 1080p. To connect a PC, use the PC IN jacks.

•Be sure to use only an HDMI cable that bears the HDMI logo.

Video game

Connect to the S video jack

1

equipment, DVD

or the video jack

 

 

1 or 3, and

player or VCR

the audio jacks

 

1 or 3. To

 

EI

avoid picture noise, do not connect

 

the camcorder to the video jack

 

 

 

1 and the S video jack

1

 

at the same time. If you connect

 

mono equipment, connect to the L

 

(MONO) jack

1 or 3.

 

 

 

 

 

 

 

 

 

DVD player with

Connect to the component jacks

component output

and the audio jacks

 

/

1 or

 

F

2.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Hi-Fi audio

Connect to the audio output jacks

equipment G

 

 

to listen to the sound from the

 

 

 

TV on Hi-Fi audio equipment.

 

To turn off the sound of the TV

 

speakers, set “Speaker” to “Off”

 

(page 29).

 

 

 

 

 

 

 

 

 

 

 

 

 

DVD recorder or

Connect to the video output jacks

VCR H

 

 

to record the image from the

 

TV. Connect to the audio output

 

jacks

 

 

to record the sound from

 

 

 

the TV on the DVD recorder or

 

VCR.

 

 

 

 

 

 

 

 

 

 

 

 

 

PC J

Connect to the PC IN jacks. It is

 

recommended to use a PC cable

 

with ferrites.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Programing the remote

If you have Sony VCRs/DVDs and Sony DVD Home Theater Systems/Amplifiers, do the following procedure to program the remote so that you can operate them using this remote.

Note

Before you start, look up the three-digit code for your equipment from the “Equipment’s codes” on page 38.

1

2

 

1

Using

 

3

 

Optional

 

 

1

Press and hold the DVD, VCR or AMP

Equipment

 

function button you want to program on the remote, then press, keeping the function button pressed down.

The selected function button (DVD, VCR or

AMP) will flash.

2 Press the number buttons to enter the three-digit code while the button is lit. If code is not entered within 10 seconds, you must perform the step 1 again.

3 Press .

When the programing is correct, the selected function button will flash twice, and when not, it will flash five times.

Continued

37 GB