Messages
One of the following messages may appear or flash in the display during operation.
Disc/ Tape/ Timer
No Disc
There is no disc on the disc tray.
No Tab
You cannot record onto the tape because the tab has been removed from the tape.
No Tape
There is no tape in the tape deck.
Not in Use
You have pressed a button those operation is not allowed or invalid at that time.
OFF TIME NG!
The on time and off time of Play Timer or Recording Timer is the same.
PUSH SELECT!
You tried to set the clock or timer during timer operation.
Push STOP!
You have pressed PLAY MODE on the remote during playback.
Reading
The system is reading information of the disc. Some buttons are not available.
NO STEP
You have cleared all the steps you programmed.
OVER
You have reached the end of the disc while pressing M during playback or pause.
Step Full!
You tried to program more than 25 steps.
SET CLOCK!
You pressed CLOCK/TIMER SELECT on the remote before the clock is set.
SET TIMER!
You pressed CLOCK/TIMER SELECT on the remote before Play Timer or Recording Timer is set.
USB device
Reading/USB Reading
The system is reading information of the USB device. Some buttons are not available.
Data Error
You tried to play back an MP3 audio track that is not playable (page 51).
Device Error
The USB device could not be recognized or an unknown device is connected.
Fatal Error!
The USB device was removed during recording or erasing operation, and may have been damaged.
NO STEP
All of the programmed tracks have been erased.
Not Supported
An unsupported USB device is connected or the USB device is connected through an USB hub.
No Track
No playable MP3 audio track is loaded in the system.
Not in Use
You tried to perform a specific operation under conditions where that operation is prohibited.
Over Current
An over current was detected.