Listening to a non-preset radio station
You can use manual tuning to tune in a station with a weak signal if you know the frequency of the station.
Use buttons on the remote for the operation.
1 Press TUNER/BAND repeatedly until “FM” or “AM” lights up in the display.
2 Press TUNING MODE repeatedly until “MANUAL” lights up in the display.
3 Press +/– repeatedly to tune in the station you want.
You can also use TUNING +/– on the unit.
To improve tuner reception
When tuner reception is poor, set the CD/ USB power manage function to “CD/USB POWER OFF”. The default setting is “CD/USB POWER ON”.
Use buttons on the unit for the operation.
1Press CD.
2Press "/1 to turn off the system.
3Press "/1 while holding down x.
The system turns on automatically. “CD/USB POWER OFF” appears in the display.
To set to “CD/USB POWER ON”
Repeat the procedure above and “CD/ USB POWER ON” appears in the display.
Notes
•When “CD/USB POWER OFF” is selected, disc and USB device access time is increased.
•There is no power supply to USB device during TUNER function with the CD/USB power manage function is set to “CD/USB POWER OFF”. Therefore, when a USB device is connected, it cannot be recognized.
To change the AM tuning interval
The factory setting for AM tuning interval is 9 kHz (or 10 kHz for some areas). Use the buttons on the unit for the operation.
1Press TUNER/BAND repeatedly until “AM” lights up in the display.
2Press "/1 to turn off the system.
3Press "/1 while holding down
ENTER.
The system turn on automatically.
“AM 9K STEP” or “AM 10K STEP” appears in the display.
When you change the interval, all the AM preset stations are erased.
Tips
•To improve broadcast reception, adjust the supplied antennas, or connect an external antenna.
•When an FM stereo program has static noise, press FM MODE on the remote repeatedly until “MONO” lights up in the display. There will be no stereo effect, but the reception will improve.