Playback does not start.
•Turn off the system, then connect the USB device again.
•Connect the supported USB device (page 6).
•Press NX (or N on the remote) to start playback.
Playback does not start from the first track.
•The system is in Program Play or Shuffle Play. Press PLAY MODE on the remote repeatedly until “SHUF” or “PROGRAM” lights off from the display.
Tracks cannot be played back.
•USB storage media formatted with file systems other than FAT16 or FAT32 are unsupported.*
•If the USB storage media has been partitioned, only the MP3 audio tracks in the first partition would be played back.
•Files that are encrypted or protected by passwords, etc. cannot be played back.
•The system can recognized up to
–997 folders on the USB device
–999 tracks on the USB device
•The system can play back to a depth of 8 folders.
•The MP3 audio track does not have the extension “.MP3”.
•The MP3 audio tracks in format other than MPEG 1 Audio Layer 3 cannot be played back.
•MP3 audio tracks in MP3 PRO format cannot be played back.
•The data is not in MP3 format.
*This system supports FAT16 and FAT32, but some USB storage media may not support all of these FAT. For details, see the operating instructions of each USB storage media or contact the manufacturer.
Tuner
The radio presetting is canceled.
•The power cord is disconnected or a power failure occurred for longer than half a day. Redo “Listening to a preset radio station” (page 31).
There is severe hum or noise. (“TUNED” or “STEREO” flashes in the display)
•Set the proper band and frequency (page 31).
•Connect the antenna properly (page 15).
•Find a place and an orientation that provide good reception, then set up the antenna again. If you cannot obtain good reception, we recommend that you connect a commercially available external antenna.
•The supplied FM lead antenna receives signals along its entire length, so make sure you extend it fully.
•Locate the antennas as far away from the speaker cords as possible.
•Try turning off the surrounding electrical equipment.
•Set the CD/USB power manage function to “CD/USB POWER OFF” (page 32).
A stereo FM program cannot be received in stereo.
•Press FM MODE on the remote repeatedly until “MONO” lights off from the display.
Tape deck
The tape does not record or playback, or there is a decrease in sound level.
•The tape heads are dirty (see “Cleaning the tape heads” on page 58).
•The record/playback heads are magnetized (see “Demagnetizing the tape heads” on page 58).