The tape does not erase completely.
•The record/playback heads are magnetized (see “Demagnetizing the tape heads” on page 58).
There is excessive wow or flutter, or the sound drops out.
•The capstans or pinch rollers are dirty (see “Cleaning the tape heads” on page 58).
Noise increases or the high frequencies are erased.
•The record/playback heads are magnetized (see “Demagnetizing the tape heads” on page 58).
The tape does not record.
•No tape is loaded. Load a tape.
•The tab has been removed from the tape. Cover the broken tab with adhesive tape (page 58).
•The tape has reeled to the end.
The system cannot play back the reverse side of the tape in Deck A or Deck B.
•The system only can play back front side of the tape in Deck A and Deck B. This is not a malfunction.
The system cannot record the reverse side of the tape in Deck B.
•The system only can record front side of the tape in Deck B. This is not a malfunction.
When you press . or >, “Not in
Use” flashes in the display.
•The system does not have AMS (Automatic Music Sensor) function. This is not a malfunction.
The recorded sound has echo effect.
•Before you start recording, press FLANGER, DELAY, CHORUS and AQUA repeatedly to turn off the effector mode.
Optional components
There is no sound.
•Refer to General item “There is no sound.” (page 49) and check the condition of the system.
•Connect the component properly (page 47) while checking:
–if the cords are connected properly.
–if the cord plugs are firmly inserted all the way.
•Turn on the connected component.
•Refer to the operating instructions supplied with the connected component and start playing.
If the system still does not operate properly after performing the above measures or other troubles not described above occur, reset the system as follows:
Use the buttons on the unit for the operation.
1Unplug the power cord.
2Plug in the power cord again.
3Press "/1 to turn on the system.
4Press x, ENTER and "/1 at the same time.
“COLD RESET” appears in the display.
The system is reset to the factory settings. You should set the settings you made, such as the preset stations, clock and timer.
Information Additional