Turning off the display
— Power Saving Mode
The demonstration display and the clock display can be turned off to minimize the amount of power consumed during standby mode (Power Saving Mode).
Press DISPLAY repeatedly while the system is turned off.
Demonstration1) tNo display (Power Saving Mode) t Clock2) t Demonstration t…
1)The display changes and the indicators flash even when the system is turned off.
2)The clock display automatically turns to Power Saving Mode after 8 seconds.
Note
You cannot perform the following operations during Power Saving Mode:
–Setting the clock (page 18).
–Changing the AM tuning interval (page 32).
–Turning on the system by pressing the function buttons (CD, TUNER/BAND, TAPE A/B, AUDIO, VIDEO or USB ).
–Changing the CD/USB power manage setting (page 32).
Changing the lighting effect of the beam
— BUILT-IN BEAM
1 Press BEAM MODE repeatedly to select the FRONT BEAM and
BOTTOM BEAM.
FRONT BEAM is located at the front side of the unit and reacts according to the high frequency (treble) of the music.
BOTTOM BEAM is located at the bottom side of the unit and reacts according to the low frequency (bass) of the music.
2 Turn OPERATION DIAL to select the setting you want.
Setting | Effect |
F.BEAM ON, | The front and bottom |
B.BEAM ON | beam lights up. |
|
|
F.BEAM 1, | The front and bottom |
B.BEAM 1 | beam flashes according |
| to the audio source. |
|
|
F.BEAM 2, | The front and bottom |
B.BEAM 2 | beam flashes according |
| to the audio source. |
| The flashing speed |
| depends on the audio |
| source. |
|
|
F.BEAM OFF, | The front and bottom |
B.BEAM OFF | beam lights off. |
|
|
3 Press ENTER.
To adjust the brightness of the beam
Refer to “BEAM DIMMER” setting in “Changing the display” (page 44).
Tip
You can change the lighting effect of the beam by pressing FRONT and BOTTOM
Operations Other